Cypress Semiconductor CYBLE-014008-00 Bluetooth Chip 4.1, Модуль

CYBLE-014008-00 EZ-BLE Bluetooth Module

The CYBLE-014008-00 module contains all the necessary components to add low-power Bluetooth BLE wireless connectivity to a project design. It includes a royalty-free BLE stack compatible with the Bluetooth 4.1 standard. PSoC Creator™ provides an integrated design environment (IDE) to configure, develop, program and test a BLE application.

CY8C4 48MHz Cortex-M0 core PSoC4 with 128KB Flash memory, 16KB RAM
RF Frequency Range: 2400 to 2482MHz ISM band
RF Power Output: up to +3dBm
Receiver Sensitivity: -89dBm
OTA Data Rate: 1Mbps
Up to 25 x GPIO
CapSense™ Sigma-Delta touch sensing with SmartSense™ hardware tuning
8-channel 12-bit, 1Msps ADC with internal reference, sample-and-hold (S/H) and channel sequencer
2 x current DACs (IDACs) for general-purpose or capacitive sensing applications on any pin
Low-power comparator that operates in Deep-Sleep mode
2 x serial communication blocks (SCB) supporting I²C (master/slave), SPI (master/slave), or UART
LCD drive supported on all GPIOs (common or segment)
4 x programmable logic blocks called universal digital blocks, (UDBs), each with eight macrocells and datapath
4 x configurable operational amplifiers
PCB antenna
Bluetooth Smart Radio and Subsystem (BLESS) contains Physical Layer (PHY) and Link Layer (LL) engines
Embedded AES-128 security engine
BLE protocol stack supporting generic access profile (GAP) Central, Peripheral, Observer and Broadcaster roles
Standard BLE profiles and services
Power modes: Active, Sleep, Deep Sleep, Hibernate and Stop
Power supply +1.8V to +5.5Vdc
Operating temperature range: -40 to +85°C
Dimensions: 11 x 11mm, SMT format
Applications: Short range communication for the Internet of Things (IoT)

Note

An evaluation board is available under RS Part No. 124-4198.

Approvals

CE, FCC, IC, MIC, KC

Datasheet