Teledyne LeCroy HVFO103 Oscilloscope Probe, Probe Type: High Voltage 60MHz 35kV, Щупы для осциллографа

Teledyne LeCroy Oscilloscope Probe

The Teledyne LeCroy oscilloscope probe is affordable and optimally designed for measurement of small signals floating on an HV bus in power electronics designs or for EMC, EFT, ESD and RF immunity testing sensor monitoring. It far surpasses the measurement capabilities and signals fidelity of both conventional HV differential probes and acquisition systems that rely on galvanic high voltage isolation. Also, it mitigates the need to rely on dangerous test set-ups that require floating the oscilloscope and probe.
Note:
Spare HVFO103-XMITTER amplifier/modulating transmitters are available. Having a spare permits constant operation - charge one while the other is being used.
Supplied with:
1 x Amplifier/modulating transmitter
1 x demodulating receiver
1.1-metre fibre optic cable
1 x USB charging cable and 1 x micro gripper set

Features and Benefits

Bandwidth is DC to 60MHz 1GHz (–3dB)
Probes selectable tips from ±1V to ±40V
Common mode voltage range is ±35kV (DC+Peak AC)
Input impedance is 1Mohm ll34pF each side to ground
Maximum input voltage to earth is ±35kV (DC+Peak AC)
Non-destructive max. input voltage is 5 times the operating voltage rating
Offset capability determined by oscilloscope offset available in a given gain (V/div) setting after accounting for total probe attenuation
CMRR (typical) is 140dB (100Hz), 120dB (to 1MHz), 85dB (to 10MHz), 60dB (to 60MHz)
Ambient operating temperature ranges between 0°C and 50°C
It also reduces noise, distortion, ringing, overshoots, and transients on the measured signal.
Reduced DUT loading, better pulse response compared to conventional HV differential
Eliminates need to float the oscilloscope ProBus-compatible with many Teledyne LeCroy oscilloscopes

Applications

Upper-side gate drive signal measurements
Floating control signal or sensor voltage measurements
EMC, EFT, ESD and RF immunity testing and system optimization
Small signal measurements with the high common-mode voltage

Certifications

Low Voltage Directive 2014/35/EU(IEC/EN 61010-031:2015
EMC Directive 2014/30/EU (IEC/EN 61326-1:2013)
UL 61010-031 Listed
CAN/CSA - C22.2 No. 61010-031-07 Listed

Datasheet