184-10329 HTWD-PN-80X100-PVC-GY, HellermannTyton HTWD-PN Grey Slotted Panel Trunking - Open Slot, W80 mm x D100mm, L2m, PVC

T1E wiring ducts are used in control panels, switching systems, and especially electronic control systems.

Wide slots suitable for large-diameter wires
Wide fingers provide additional wire support
Smooth, burr-free edges protect installers from injury and wires from damage
Fingers can be removed with no sharp edges at pre-notched snap-off points
Further pre-notched snap-off point at base of sidewall allow cutting out and removing sections of sidewall with no sharp edges
Raised mounting points for easily, quickly and securely fastening wire retainers and other accessories prior to cabling
Wire retainers and accessories leave no protruding parts below surface of duct
Duct covers are easy to mount and remove, yet hold securely even in a vertical position and under vibration
Cover is flush with side of duct, allowing for tight, contiguous placement of ducts
Additional retainer nub on fingers on ducts height 80 and above to prevent cables from slipping
Base perforation according to DIN EN 50085

Narrow slots suitable for small-diameter wires
Smooth, burr-free edges protect installers from injury and wires from damage
Fingers can be removed with no sharp edges at pre-notched snap-off points
Further pre-notched snap-off point at base of sidewall allow cutting out and removing sections of sidewall with no sharp edges
Raised mounting points for easily and securely fastening wire retainers and other accessores prior to cabling
Wire retainers and accessories leave no protruding parts below surface of duct
Duct covers are easy to mount and remove, yet hold securely even in a vertical position and under vibration
Cover is flush with side of duct, allowing for tight, contiguous placement of ducts
Additional retainer nub on fingers on ducts height 80 and above to prevent cables from slipping
Base perforation according to DIN EN 50085

Datasheet