FPF1009 Power Switch Type, onsemi FPF1009, Load Power Switch IC 6-Pin, WDFN

The FPF1007/8/9 are low RDS P-Channel MOSFET load switches offered in a selection of 10μs, 80μs, and 1ms slew rate turn-on options for transient/inrush current control. To support trends in mobile application requirements, the minimum operating input voltage has been reduced down to 1.2V, the input current leakage has been minimized to extend battery life, and the ESD-protection has been designed to withstand a minimum of 8kV (HBM) and 2kV (CDM). The switch is controlled by an active-high logic input (ON pin), allowing it to interface directly with a low-voltage control signal. An internal ON pin pull-down resistor protects against an unintentional device turn-on while in the initial state. An on-chip pull-down resistor on the output is enabled when the switch is turned-off and provides a quick and robust discharge of the output load.
1.2 to 5.5V Input Voltage RangeTypical RON = 30 mΩ @ VIN = 5.5VTypical RON = 40 mΩ @ VIN = 3.3VFixed Three Different Turn-on Rise-time 10μs/80μs/1msLow 10μA @ VIN = 3.3V Quiescent CurrentInternal ON Pin Pull DownOutput Discharge FunctionESD Protection above 8000V HBM and 2000V CDMApplicationsMedia TabletsStorage \u0026 PeripheralsMobile HandsetsWireless LAN Card \u0026 Broadband AccessPMP/MP3 Players