197543 M30-PV30, Eaton Pull Release Emergency Stop Push Button, Panel Mount, 30mm Cutout, IP65, IP66, IP69

Eaton Emergency Stop Push Button, 30mm Diameter, Pull-To-Release Unlocking Method - E-STOP Series - 197543 M30-PV30

Control the activity of industrial equipment like power units and conveyor belts with this emergency stop push button from Eaton. As it uses a pull-to-release unlocking method, you need to manually reset the button after actuation. This adds an extra level of safety as it prevents accidental release before fault conditions have been cleared. The 30mm diameter means the unit is approximately 30% smaller than similar products, so it won't add bulk to busy setups.

Features & Benefits

• Wide operating temperature range between -25°C and +70°C makes it suitable for use in extreme conditions
• Red colour clearly stands out in your installation for quick identification as an emergency device
• Long service life of 70,000 operations
• Resists mechanical shocks up to 50g to withstand harsh industrial settings

Does this unit have an IP rating?

The housing on this push button has IP65, IP66 and IP69 ratings, which indicate that it's fully dust-tight and protected against high-pressure jets of water.

How do I mount this push button?

This unit is designed for panel mounting, so installation is straight-forward and quick.

Note

Eaton formerly known as Moeller

Datasheet - M30-PV30

Eaton Small E-Stop catalogue

Instruction Sheet - RMQ-Titan M22-PV30, M30-PV3