1300580033, Brad from Molex 130058 Female Dust Cap IP65 Rated, Nylon, Пылезащитный колпачок

Dust Protection Caps

Dust caps for plugs and sockets protecting the connectors from water, dirt and damage, when they are not connected.

Will remain attached with rubber eyelet arrangement
IP67 when connected

Brad from Molex Dust Cap, 28.6mm Diameter, IP65 - 130058 Series - 65-0300

Protect your connectors from environmental hazards with this Brad from Molex dust cap. It's made of Delrin polyoxymethylene material (POM). This gives it metal-like stiffness and high resistance to wear, so you can count on it to withstand repeated use. A dust cap like this one is frequently used in industrial areas to maintain sealing integrity when a connector isn't mated with the receptacle.

• IP65 (ingress protection) rating indicates it's protected against dust and low-pressure water jets
• Dust cap surface is easy to clean
• Knurled grip surface ensures it's easy to screw on and off either bare-handed or with gloves

Applications

• Process and packaging equipment
• Robotics and automation
• Construction and installation sites

Does this cap conduct electricity?

No – it's made from a material which offers good electrical insulating properties.

Can this dust cap protect the receptacle from immersion in water?

No, it can't. However, Brad from Molex offers a dust cap with a lanyard (67-0300) which is built to the same specification and has an IP67 (ingress protection) rating. This means it's dust-tight and able to withstand 30 minutes immersion in 1m of water.

65-0300 Dust Cap Dimensional Drawing

RJ-Lnxx Series Physical Media

Datasheet - 65-0300