0203137, Phoenix Contact, EB 10-10 Jumper Bar for Terminal Block

Universal Terminals

Universal terminals moulded in polyamide to fit both 'G' and 'Top Hat' rail.
Screw conductor securing with closed screwdriver shafts. Available conductor acceptance sizes, 2.5mm² to 35mm². The range comprises of grey (phase), blue (neutral), and yellow/green (earth) terminals. A 10-way insertion (jumper) bridge is also available, as is a 35mm rail end bracket.

Individual terminals and complementary accessories

Approval Category II 2 GD EEx e II Cert. No. KEMA 98ATEX1651U

EB 10-10 Jumper bar - 0203137

Phoenix Contacts 0203137 jumper bar is a 10-pole jumper that is used to connect a terminal to another. This module has copper contacts for the best conductivity, with a polyamide plastic grip. Not to mention, the grip is titled at a 45-degree angle to it allows you to easily insert & remove the jumper bar without much force. From pin to pin there is a 10mm pitch - that's universal for most spacing between ports on terminal blocks.

These jumper bars are brilliant if you do not want to constantly use lots of wires and manually plug them in to connect a circuit. Jumper bars not only save time, but they also look far neater & with a flammability rating of 'V0', this module is also a little safer.

Features and benefits:

• 10mm pitch between contacts


• Easy to use with a 45-degree angled grip for easy insertion


• Saves time over conventional methods of plugging in strands of wires


• Plug-in and go. No set-up required after installation.

Applications:

These jumper bars are typically used in industrial control panels, in cabinets to connect terminal blocks together to make a full circuit. Whether it is seeing statuses or bypassing a connection point, this jumper can do it.

Approvals

E Exei/II; KEMA

0203137 Datasheet

0203137 Safety information