1419629, Phoenix Contact Male 4 way M12 to Unterminated Sensor Actuator Cable, 500mm, Кабельная сборка

M12 Flush-type connector with individual litz wires, rear mounting

Sensor/ actuator flush-type connector
M12 SPEEDCON
Rear/ screw mounting with M16 thread
With 0.5 m TPE litz wire

Phoenix Contact Sensor Actuator Cable, 4A Current Rating, 500mm Length - SACC-DSI-M12MS-4CON-M16/0.5 - 1419629

Looking for a dependable and long-lasting data transmission option for your sensors and industrial equipment? Choose this sensor-actuator cable from Phoenix Contact. Its 4-core design means that you can transmit data to four circuits at the same time, reducing cabling requirements.
At one end, there's an M12 connector with tinned copper conductors that have a low electrical resistance of around 57.6 mΩ/m, providing a stable connection. Gold plating makes the connector resistant to corrosion, so you can depend on it for long-term performance. Die-cast zinc knurls lock the adapter and prevent it from loosening in vibrating systems. A short cable length of 500mm reduces clutter on your equipment and makes for a tidy setup.
An IP67 (ingress protection) rating indicates the cable is dust-tight and can withstand immersion in up to 1m of water for 30 minutes, so it's a good fit for marine applications.

• Light weight of 23g for easy handling and minimal strain on equipment
• Low-rated current of 4A for energy efficiency and reduced heat dissipation
• Nitrile rubber seals to protect against dust and support optimal performance

SACC-DSI-M12MS-4CON-M16/0,5