RF Solutions ZULU-868 RF Transceiver Module 868 MHz, 2.2 → 3.6V, Модуль

ZULU 868MHz ISM-Band Long-Range Transceiver Module

The ZULU-868 Transceiver module is designed to handle wireless telemetry over a distance of up to 2000m. It achieves this while consuming little power especially when is placed into one of its sleep/standby modes. The on-board DC-DC converter allows it to operate with a power supply voltage as low as 0.9V.

RF Transceiver based on Si1000 SoC with 25MHz 8051 microcontroller core, 64KB Flash memory, 4352B RAM
EZRadioPRO wireless transceiver
RF Carrier Frequency: 848 to 888MHz ISM Band
Modulation: FSK, GFSK or OOK
RF Power Output: +20dBm
Receiver Sensitivity: -121dBm @ 2000bps, GFSK, 0.1% BER
OTA Data Rate: 0.123 to 256kbps
Range: 2000m (line of sight)
Programmable packet handler
Supports Frequency Hopping Spread Spectrum (FHSS) operation
64-byte Tx and Rx FIFOs
18 x channel 10-Bit 300ksps ADC
GPIO, UART, SPI and I²C I/O ports
On-chip debug circuitry
Power supply: +1.8 to +3.6Vdc
Two built-in brown-out detectors cover sleep and active modes
Wale-Up Time: <2us
Current consumption: Less than 1uA with RTC running and radio state retained
Operating temperature range: -40 to +85°C
Available in DIP format (RS 761-9869) or SMT format (RS 761-9862)
Dimensions: 25 x 13 x 3mm (DIP), 25 x 11 x 2mm (SMT)
Applications: Remote sensing/control, local communication for the Internet-of-Things (IoT)

Note

The Zulu-868 works with the RadioPi wireless dongle for Raspberry Pi, RS 793-4418

Approvals

CE

Wireless Modules - RF Solutions

ZULU, RF Trans-Controller