POE125U-4AT-N-R, Phihong POE Injector, Инжектор

125W, 4-Port PoE Midspan Injector

4-port Power-over-Ethernet Midspan Injector injects power into ethernet cables to supply power and data to a PoE enabled devices
Fully compliant to IEEE802.3at standard
125W power supply providing full power of 33.6W to all four ports - No power management required
Supports full power mode of Cisco AP1250
Diagnostic LEDs
Over temperature, over voltage/current and short circuit protection
Output voltage protection
Gigabit compatible (10/100/1000 base-T)
Fully regulated output
RJ45 Data In and Data/Power Out sockets
Harmonic current compliance to EN 61000-3-2
EMI compliance to EN 55022 Class B and FCC Class B
UNH IOL tested
3-pin IEC320 C14 mains input socket

Note

For Industrial Use Only, not in scope of Regulation (EC) No 125/2009

Standards

EN60950-1:2001

Approvals

cUL/UL

Spare Pair and Data Pair powering - ULTRA Power midspans stk nos. 666-8211 (POE60U single-port) and 666-8220 (POE80U single-port), have a combination of Spare Pair and Data Pair powering over the full 8 wires. There are no specific IEEE standards for these yet. The midspans are compliant to the performance of 10baseT, 100baseT and 1000baseT (Gigabit). They have safety features, such as handshake detection, overload, connect and disconnect functionality as for the IEEE802.3af and IEEE802.3at standards but the handshake detection resistance is 12.5KΩ, instead of 25KΩ for the IEEE802.3af and IEEE802.3at standards

Gigabit High Power over Ethernet Midspan Data Sheet